About this item

• High-frequency oscillation, micrometer aperture, large atomization amount, fine mist particles, high spray rate. Note: The atomizing piece needs to be used together with the circuit board with the same frequency to achieve the ideal spray amount.
• Continuous spray mode: spray immediately after power on (No Switch). Input DC5V power supply, LED light is always on, always spray. Shutdown: Unplug the power and stop.
• Pay attention to both sides of the atomizing sheet: The white piezoelectric ceramic ring surface is the front spray surface, which is installed upward, All steel sheet surface is the suction surface on the back, installed downwards. If the installation is reversed, it will not be able to spray. The red wire is positive and the black wire is negative.
• Spray Principle: Piezoelectric ceramics drive metal plate high-frequency oscillation, ultrasonic liquid atomization. Micrometer-fine water molecules atomize water throughmicropores and disperse it into the air. Application: DIY spray, plant hydration humidification, landscaping atomization.
• How to use: 1. First install the atomizer plate, holder, cotton swab. 2. Connect the atomizer plate to the module port (White 1.25mm terminal). 3. Connect the power supply to the module power port (Type-C socket). 4. Press the power switch. 5. The atomizer plate will spray when it comes into contact with water.

SPECIFICATIONS:
Humidifier Module Parameter:
Rated Voltage: DC 5V
Rated Current: 300mA
Power Supply Methods: Type-C socket
Humidifier Interface: White 1.25mm terminal socket
Material: 1.2mm FR-4
PCB Size: 32*20mm, Weight: 6g
Frequency: 108KHz+3
Power: 1.5-2W
Atomization amount: Around 100ml/h
Work Temperature: 0℃~85℃
Work Humidity: 10%~90%RH


Microporous Atomizing Film Parameter:
Steel Sheet Diameter: 16mm
Outer Diameter of Silicone Ring: 20mm
Cable Length: 120mm
Weight: 2g
Frequency: 108KHz+3
Aperture: 4-5μm
Number of Holes: 740 holes
Interface: White 1.25mm terminal
Material: Piezo ceramic ring + Stainless steel


Humidifier Cotton Swab Size: 100*10mm
Black Bracket Size: 38*24mm, Weight: 4g


DIRECTIONS FOR USE:
1. Attach the atomizer to the circuit board.
2. USB DC 5V power supply.
3. Press the circuit board switch.
4. Atomizing plate suction water spray.
NOTE:
1. Do not puncture the atomizer.
2. Can not run empty.
3. Do not use fast chargers.
4. No change circuit.
5. The circuit board must not be damp.
6. All steel sides absorb water downward.
7. Rated power input.


Package Inlcuding:
2 X Atomization Module Type-C Interface Double Nozzle
4 X Microporous Atomizing Film
4 X Humidifier Cotton Swab
4 X Black Plastic Bracket